01
Hydraulic Decoiler
Grips the coil eye with hydraulic expansion and pays strip off at line speed with back-tension. Coil weight up to 10 Ton.
3D model
1250 mm coil slitting line
Our reference line — nine units and one control panel. Your line follows the same sequence, sized to your coil.
Press Run line to run the strip through the slitter head, or pick any unit to study it on its own. Every machine is also downloadable as a .glb model file.
Specification
Line data
| Coil width | 1250 mm |
|---|---|
| Thickness range | 0.3 – 3.0 mm |
| Coil weight | 10 Ton |
| Slitting speed | 80 – 120 m/min |
| No. of strips | As per requirement |
| Strip width accuracy | ±0.10 mm |
Built to your requirement. Width, thickness and coil weight are quoted as per your coil — for example 1250 mm, 1650 mm or wider, at any thickness you run.
Scope
What is included
- Machine units sized to your coil
- Electrical control panel with HMI and operator controls
- Hydraulic power packs and cylinders
- Line layout and foundation guidance
- Installation, commissioning and technical support
- After-sales service and spare parts support
Variants
- Coil width 650 – 2000 mm
- Thickness range and coil weight as per your requirement
- Single or double cone decoiler options
- Upgrade or re-conditioning of an existing line
In running order
Nine machines, one control panel
Click any unit for its own page in the 3D explorer, with the model file ready to download.
02
Coil Car
Lifts the coil on a hydraulic saddle and traverses it onto the mandrel — coil loading without the overhead crane.
3D model
03
Pinch Roll & Feeder
The line drive: precision rolls feed strip at constant tension; top roll adjusts for 0.3–3.0 mm.
3D model
04
Slitter Head
Twin hardened knife arbors shear the full width into strips in one pass — ±0.10 mm, re-settable for new widths.
3D model
05
Scrap Winder
Winds both edge trim strips into tight scrap coils at constant tension, so the line never stops for clearing.
3D model
06
Tension Stand
Pad-type drag keeps every strip tight, so finished coils wind square instead of loose or telescoped.
3D model
07
Separator
One guide disc per slit line — every strip enters the recoiler in its own lane, no cross-winding.
3D model
08
Hydraulic Recoiler
High torque winding with hydraulic mandrel expansion and a hydraulic push-off arm for the finished coil.
3D model
09
Exit Car
Takes the finished coil off the mandrel, lowers it and carries it clear for strapping and pick-up.
3D model
—
Control Panel
One operator runs the line: speeds, hydraulic pressure, coil handling, line status and faults on the HMI.
3D model
Quote this line for your coil
Send coil width, thickness range, coil weight and the strip widths you need.